The Hands Behind the Deflection Board
Four people keep the bench running — one on spine testing, one on the launch bay, one on assembly, and one holding the schedule together.
Ronan Hale
Ronan opened the studio in 2016 after six seasons reshafting clubs for a regional pro shop chain, where spine orientation was never once checked before a shaft got glued in. He's since spine-tested more shafts than he can count and trains every fitter who joins the bench personally.
Daria Wren
Daria runs most iron and wedge sessions, matching spine orientation, lie, and bounce across a full set for consistent feel club to club. She competed on the collegiate circuit before moving into fitting full time.
Ezra Fenwick
Ezra runs the build bench, assembling every set that leaves the studio and confirming each shaft's marked spine lines up correctly against the clubface before epoxy goes in. He's built clubs professionally for over a decade.
Nadia Poe
Nadia schedules every session, handles order tracking, and is usually the first voice you hear when you call the studio. She keeps the demo wall organized and makes sure every client leaves with a written report the same day.
Every Fitter Learns the Deflection Board First
New fitters spend their first month exclusively on spine testing before they're allowed to run a full session solo, and every fitter recertifies on our deflection board hardware twice a year. The goal is that your spine reading comes out the same whether you book with Ronan, Daria, or whoever's on the bench that day.
Requesting a Specific Fitter
You're welcome to request Ronan or Daria by name when you book, though availability may push your appointment out a few days. Ezra and Nadia are available for build questions or order status any time the studio is open.
Book a Fitting Session